Fax：(+86) 769 2229 0098
ADD：Tonghui Road, Dongcheng Science Park,
Greenway New Energy
ABOUT US PRODUCTS NEWS Scan QR code to follow
How to charge the Kick scooter battery
How to charge the Kick scooter battery? First, remove the battery and directly press the positive and negative clips to clamp the battery to the two holes where the motorcycle is connected to the motorcycle and then energize it.
The Kick scooter battery does not heat up during charging, which means that the charging current is relatively small, so the Kick scooter battery does not heat; the transformer plug heats up, which means that the power of the transformer is relatively small and the load during charging is relatively large. It doesn't matter, you can charge slowly, it is estimated that the charge will not be good overnight.
For Kick scooter battery from the perspective of electronic technology: the first stage is called the charging current limit stage, the second stage is called the high constant voltage stage, and the third stage is called the low constant voltage stage. Most chargers have red lights in the first and second stages, and turn green in the third stage.
The mutual conversion between the second stage and the third stage is determined by the charging current. A current greater than a certain current enters the first and second stage, and a current smaller than a certain current enters the third stage. This current is called conversion current, also called turning current.
Some correct charging methods for Kick scooter battery:
1. After the light turns green, continue charging for 2-3 hours.
2. The principle is shallow discharge (electricity) and frequent charging (electricity), and charge after 50% each time. Don't charge too frequently. This will shorten the life of the Kick scooter battery.
3. For long-term shallow Kick scooter batteries, perform a deep discharge for about 3 months, which is the so-called light recharge, which is beneficial to the activation of long-term immobile substances in the deep part of the battery. Shining means to ride until the controller battery undervoltage protection is activated.